Loading ...
Loading ...
Loading ...
31
NS-TWM45W1
www.insigniaproducts.com
INSTALLATION INSTRUCTIONS
Step 5: Power your washer
Plug the power cord into a well-grounded, 3-prong, 120 Volt 60 Hz
approved electrical outlet, protected by a 15-amp fuse or
comparable circuit breaker. Your washer is grounded through the
third prong of the power cord.
Step 6: Run a test cycle
Run a test cycle to make sure that your washer is correctly installed.
1 Load about 6 lbs. (2.7 kg) of laundry into the tub.
2 Press the /Power button to turn on your washer.
3 Turn the cycle selector to select the Rinse & Spin cycle.
4 Press the /Start/Pause button to start the test cycle. Your washer shouldn’t
rock or vibrate excessively when water fills the tub, or when washing or
spinning. Your washer should drain well during the spin cycle.
Step 7: Protect the power cord
1 Keep the power cord away at least 2.5 in. (6 cm) from the skirting line of the
wall or any sharp objects when installing.
2 Rotate the wall stand-off 90° clockwise and make sure that the wall stand-off is
in the stop position.
CAUTIONS:
• If you detect any water leaks while your washer is filling or draining, check the
water connections. See Step 2: Connect the water hoses on page 21 or Step 3:
Connect the drain hose on page 25.
• If your washer rocks or vibrates excessively, level it again. See Step 4: Level your
washer on page 29.
2.5 in. (6 cm)
Wall stand-off
Loading ...
Loading ...
Loading ...