Loading ...
Loading ...
Loading ...
INSTALLATION INSTRUCTIONS
20
www.insigniaproducts.com
Water requirements
To fill your washer in the correct amount of time, the water pressure needs to be
between 14 and 116 psi (100 to 800 kPa).
If the water pressure is less than 14 psi (100 kPa):
• The water valve may fail or may not shut off completely.
• The time it takes to fill your washer may be longer than the time your washer
controls allow. Your washer turns off and reports an error. A time-limit is built
into the controls to prevent flooding in your home if a hose becomes loose.
• Water inlet hoses must be purchased separately. You can buy inlet hoses in
various lengths up to 8 ft. (240 cm).
• To avoid the possibility of water damage:
• Make sure that the water faucets are easily accessible.
• Turn off the faucets when you aren’t using it.
• Periodically check to make sure that water isn’t leaking from the water hose
fittings.
Drainage requirements
• The recommended height for the drain standpipe is 48 in. (122 cm).
• The drain hose must be routed through the hose holder to the standpipe.
• The standpipe must be large enough to accept the outside diameter of the
drain hose.
Installing your washer
Tools you need
Step 1: Select a location
Before you install your washer, make sure that the location:
• Is a hard, level surface without carpeting or soft flooring that can obstruct
ventilation.
• Is away from direct sunlight.
• Has adequate ventilation.
• Isn’t exposed to freezing temperatures (32° F or 0° C).
WARNINGS:
• You’re responsible for providing adequate electrical services for your washer.
• To prevent unnecessary risk of fire, electrical shock, or personal injury, all wiring
and grounding must be done in accordance with the National Electrical Code
ANSI/FNPA, No.70 Latest Revision and local codes and ordinances.
• Never connect the ground wire to plastic plumbing lines, gas lines, or hot water
pipes.
Pliers
Phillips screwdriver
Level
Flat-head screwdriver
Wrench
Loading ...
Loading ...
Loading ...