Loading ...
Loading ...
Loading ...
Operation
other obstacles on the windscreen may
damage the wiper and the windscr
een wip-
er motor.
●
If necessary, remove snow and ice from
the windscreen wipers before starting your
journey.
●
Do not switch on the windscreen wipers if
the windscreen is dry. Cleaning with the
windscreen wipers while dry can cause
damage.
●
In icy conditions, always check that the
wiper blades are not frozen to the glass be-
fore using the wipers. In cold weather, it
may help to leave the vehicle parked with
the wipers in service position
›››
page 52.
Note
●
The windscr
een and window wipers only
function when the ignition is switched on
and the bonnet or rear lid, respectively, are
closed.
●
The rear wiper is automatically switched
on when the windscreen wiper is on and the
car is in reverse gear.
Wiper functions
Windscreen wipers performance in differ-
ent sit
uations
●
If you stop the vehicle with the windscreen
wiper in position 1 or 2, it will automatically
change to a lower position speed. The set
speed will be resumed when the vehicle pulls
away.
●
The air conditioner comes on for approxi-
mately 30 seconds in air recirculation mode
when the windscreen washer is activated,
to prevent the smell of the windscreen wash-
er fluid entering the inside the vehicle.
●
When wiping at intervals, the intervals vary
according to the speed. The higher the vehi-
cle speed the shorter the intervals.
Note
●
The wiper will try t
o wipe away any ob-
stacles that are on the windscreen. The
wiper will stop moving if the obstacle
blocks its path. Remove the obstacle and
switch the wiper back on again.
●
The windscreen will be wiped again ap-
proximately 5 seconds after the wind-
screen washer has been activated, provi-
ded the vehicle is moving (“drip” function).
If you activate the wipers less than 10 sec-
onds after the “drip” function, a new wash
sequence will begin without performing the
last wipe. For the “drip” function to work
again, you have to turn the ignition off and
then on again.
Rain sensor
Fig. 108
Wiper lever: adjust the rain sensor
A.
Fig. 109
Rain sensor sensitive surface
The rain sensor controls the frequency of the
windscr
een wiper intervals, depending on the
amount of rain
›››
. The sensitivity of the rain
sensor can be adjust
ed manually. Manual
wipe
›››
page 127.
Move the lever to the required position
›››
Fig. 108:
128
Loading ...
Loading ...
Loading ...