Loading ...
Loading ...
Loading ...
16
RFID ANTENNA
WIEGAND
REQUEST TO EXIT
READER
PUSH
BUTTON
PROXIMITY
SENSOR
KEYPAD
MAGLOCK
LIGHT
ALARM BYPASS
OR OR
OR
OR
OR
DOOR STRIKE
RED LED - brown
GREEN LED - orange
DATA 1 - white
NEUTRAL
DATA 0 - green
GROUND - black
12Vdc - red
PRIMARY RELAY
AUXILIARY RELAY
Model MG1300
Model HES(RS) 1006CLB(R)
NORMALLY CLOSED
Use 18-22 AWG
Use 18-22 AWG
COMMON
NORMALLY OPEN
NORMALLY OPEN
COMMON
COMMON
COM
COM
NO
LOAD
LINE
Isolation
Relay
Low
Voltage
Power
Supply
NO
NO COM
NO COM
NC
Power for Maglock
(Not Provided) DO
NOT use the power
supply for the controller
Power for Maglock
(Not Provided) DO
NOT use the power
supply for the
controller
For AC Power:
Install a Siemens
S10K30MOV
(Metal Oxide Varistor)
or equivalent
For AC Power:
Install a Siemens
S10K30MOV
(Metal Oxide Varistor)
or equivalent
For DC Power:
Install a 1N4005 diode
or equivalent
For DC Power:
Install a 1N4005 diode
or equivalent
COM
REX
NOTES:
• The length of the unshielded
wires should be kept to a minimum
to avoid electrical noise.
• When extending the reader connection,
the shield wire must be connected to an
earth ground bus, but should NEVER be
connected at the reader.
NOTE: Power supply for
RFID antenna is not provided.
DO NOT use the power supply
for the door controller.
NOTE: For KPR2000 keypad
wire the pink and black (ground)
wires together.
NOTE: DO NOT run high voltage power within the CAP2D enclosure. This
configuration has not been evaluated by UL. Use UL Listed Power Limited
Power Supplies and UL Listed Isolation Relays.
Acceso de puerta
Desconecte la alimentación ANTES de realizar las conexiones eléctricas. A continuación encontrará un ejemplo de una confi guración
de cableado para el acceso de puerta. El acceso de puerta se puede conectar por cable a la puerta 1 o 2.
NOTA: Las fuentes de alimentación deberán ser de salida limitada
de potencia 294 o 603 comerciales con certifi cación UL.
INTRODUCCIÓN PREINSTALACIÓN
REDCABLEADO CONTROL DE ACCESO
INSTALACIÓN
Loading ...
Loading ...
Loading ...