Loading ...
Loading ...
Loading ...
15
INTRODUCTION PRE-INSTALL NETWORKWIRING ACCESS CONTROL INSTALL
Gate Access
Disconnect power BEFORE making electrical connections. Below is an example of a wiring setup for gate access. Gate access can be
wired to Door 1 or 2.
NOTE: Power Supplies shall be UL Listed Commercial 294 or 603 power limited output Power Supplies.
LAN
ADMIN
DRY
RLY1
WET
PSE1
PoE
DRY
WET
RLY2
HRTBT
READER 1
IO 1
REX
COM
DOOR
RED GRN 12V BUZ GND D1 D0
IO 2
REX
COM
DOOR
READER 2
RED GRN 12V BUZ GND D1 D0
NC
COM
NO
NC
COM
NO
NC
COM
NO
NC
COM
NO
-12IN+
+
-
RFID ANTENNA KEYPAD
REQUEST TO EXIT
PRIMARY RELAY
AUXILIARY RELAY
WIEGAND
READER
PUSH
BUTTON
GATE OPERATOR
EXTERNAL FREE EXIT
LOOP DETECTOR
OR OR
OR
NOTES:
• The length of the unshielded
wires should be kept to a minimum
to avoid electrical noise.
• When extending the reader connection,
the shield wire must be connected to an
earth ground bus, but should NEVER be
connected at the reader.
NOTE: Power supply for
RFID antenna is not provided.
DO NOT use the power supply
for the door controller.
NOTE: For KPR2000 keypad
wire the pink and black (ground)
wires together.
RED LED - brown
GREEN LED - orange
DATA 1 - white
DATA 0 - green
GROUND - black
12Vdc - red
COM
REX
OPEN
COM
COM
NC
NO
Common
(Exit Input)
Model MG1300
NORMALLY CLOSEDUse 18-22 AWG
COMMON
Power for Maglock
(Not Provided) DO
NOT use the power
supply for the
controller
For AC Power:
Install a Siemens S10K30MOV
(Metal Oxide Varistor) (provided) or equivalent
For DC Power:
Install a 1N4005 diode
or equivalent
Loading ...
Loading ...
Loading ...