Loading ...
Loading ...
Loading ...
accident, reset the system by following the
procedure described below. If you have any
doubt, contact an authorized dealer.
Enhanced Accident Response System Reset
Procedure
After the event occurs, when the system is
active, a message regarding fuel cutoff is
displayed. Turn the ignition switch from igni-
tion AVV/START or MAR/ACC/ON/RUN to ig-
nition STOP/OFF/LOCK. Carefully check the
vehicle for fuel leaks in the engine compart-
ment and on the ground near the engine
compartment and fuel tank before resetting
the system and starting the engine.
Depending on the nature of the event the left
and right turn signal lights, located in the
instrument panel, may both be blinking and
will continue to blink. In order to move your
vehicle to the side of the road, you must
follow the system reset procedure.
Customer Action
Customer Will See
NOTE:
Each step MUST BE
held for at least two
seconds
1. Turn ignition
STOP/OFF/LOCK.
(Turn Signal Switch
Must be placed in
Neutral State).
2. Turn ignition MAR/
ACC/ON/RUN.
Right turn light
BLINKS.
Left turn light is OFF.
3. Turn right turn
signal switch ON.
Right turn light is
ON SOLID.
Left turn light
BLINKS.
4. Place turn signal
in neutral state.
Right turn light is
OFF.
Left turn light
BLINKS.
5. Turn left turn sig-
nal switch ON.
Right turn light
BLINKS.
Left turn light is
ON SOLID.
6. Place turn signal
in neutral state.
Right turn light
BLINKS.
Left turn light is OFF.
Customer Action
Customer Will See
NOTE:
Each step MUST BE
held for at least two
seconds
7. Turn right turn
signal switch ON.
Right turn light is
ON SOLID.
Left turn light
BLINKS.
8. Place turn signal
in neutral state.
Right turn light is
OFF.
Left turn light
BLINKS.
9. Turn left turn sig-
nal switch ON.
Right turn light is
ON SOLID.
Left turn light is
ON SOLID.
10. Turn left turn
signal switch OFF.
(Turn Signal Switch
Must be placed in
Neutral State).
Right turn light is
OFF.
Left turn light is OFF.
11. Turn ignition
STOP/OFF/LOCK.
SAFETY
108
Loading ...
Loading ...
Loading ...