Loading ...
Loading ...
Loading ...
27
When a continuous series of beeps sounds, all the lights
turn off onthe control panel and a number appears on the
display, a fault hasoccurred. The dryer will automatically
enter this mode if a fault occurs. The word ‘Fault’ will be
shown in the control panel display followed by a number,
refer to example. To stop the beeps, touch any button then
perform the following steps:
1 Turn your machine off at the power point.
2 Wait one minute and turn it back on.
3 Check your machine is installed correctly
(refer to ‘Installation instructions’ section).
4 Remove your load from the dryer and retry.
5 Perform a ‘Time Dry’ cycle, eg Time Dry for 30 minutes.
6 If the fault re-occurs repeat steps
1
and
2
.
7 If the machine still will not work call a Fisher & Paykel
trained and supported service technician to arrange service
(referto‘Customer care’ section). Record the fault code
number displayed and the serial number of your dryer
(locatedon the rear of the machine, or on the insideof the
door below the glass) before calling. The fault code will
indicateto the service technician what the problem could
potentially be.
If a fault code is being displayed, you can still turn your dryer off by pressing ‘POWER’.
FAULT CODES
FAULT
E2
Contact the F&P
Customer Care Centre
Time Dry
Set Time
30min
Loading ...
Loading ...
Loading ...