Loading ...
Loading ...
Loading ...
INSTALLATION INSTRUCTIONS
8
Installation options
Your dryer can be installed one of two ways, either freestanding, or stacked on top
ofaFisher & Paykel front loading washer.
1
Free standing
The dryer stands on the floor and can easily be moved into position.
2
Stacking
Your dryer has been designed to be able to be stacked on top of any Fisher & Paykel
frontloading washer. A stacking kit MUST BE USED between the products and fitted
correctly to the washing machine and dryer, as per the stacking kit instructions.
– Stacking Kit White: Part No. 428159. This Stacking kit is available from your
Fisher&Paykel dealer, online or from a Fisher & Paykel service technician.
1 Move the machine into the desired position. Do not lift the dryer by the top panel.
2 Have a minimum clearance on all sides of at least 20mm.
3 Install the machine on a stable and level floor (if not stacking on top of a front
loadingwasher).
Do not install your dryer in such a way that the dryer door cannot be opened fully.
Do not install the dryer outside, in a damp place, where there is a risk of freezing,
whereit may be rained on, in direct sunlight or close to a source of heat.
Do not place your machine on top of its power cable.
Levelling the machine
It is IMPORTANT to level the machine to ensure the machine runs efficiently with minimal
noise. The dryer should be levelled in as close to its final position as possible so it stands
balanced evenly on all four feet. Ensure the dryer does not rock in any direction.
The dryer comes with four adjustable feet. Wind
all four feet up or down until the dryer is correctly
level. A spirit level can assist with this process.
The machine is considered level when the bubble
sits in the centre (ie within the two lines or the
circle), when the spirit level is placed flat on top
of your dryer, in the directions from:
1 left to right
2 back to front, and
3 corner to corner.
Never unscrew the feet completely from their housings.
Note: After levelling, the corners of the dryer cabinet should be clear of the floor
andthemachine must not rock in any direction.
Levelling the feet
Loading ...
Loading ...
Loading ...