Loading ...
Loading ...
Loading ...
INSTALLATION INSTRUCTIONS
10
Electrical connection
1 This appliance must be connected to a 220V – 240V,50Hz, sinusoidal, 10Aelectricalsupply.
2 Uncoil the power cord, remove and discard the plastic pin cover and plug into a powersocket.
3 Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
Check the power cord for damage and make sure it is not squashed or twisted
wheninstallingthe dryer.
Always remove the power cord from the power socket by the plug, not by the cord.
IMPORTANT!
Do not touch or operate the machine with wet hands or with bare-feet.
A damaged power cord must be replaced by a Fisher & Paykel trained and supported
service technician, its service agent or similarly qualified persons inorderto avoid a hazard.
The appliance must not be operated until it is repaired, asthere is risk of electric shock.
Do not operate this machine if it has been damaged during transport. Contact your
Fisher&Paykel dealer or Fisher & Paykel trained and supported servicetechnician.
WARNING!
The appliance must not be supplied through an external switching device, such as
atimer, or connected to a circuit that is regularly switched on and off by a utility.
Completing the installation
Installation test cycle
IMPORTANT!
Ensure the installation test cycle is completed before you dry any items in your dryer.
This is to check that your dryer is installed correctly and that it is functioning properly
prior to use.
1 Turn your dryer on by pressing the ‘POWER’ button.
2 Select the ‘Time Dry’ cycle for 30 minutes. Ensure the drum is empty and the door
isclosed (you will hear it click shut).
3 Touch the button. The drum will start rotating.
– Observe the machine for any problems.
– The dryer will beep and display any faults on the screen if there are any problems.
Refer to ‘User Prompts’ and ‘User warnings’.
4 At the completion of the cycle, open the door and check that there is warmth inside
thedryer. This indicates the dryer is operating normally.
IMPORTANT!
If there are any problems, you must address these before proceeding with normal use.
The dryer will automatically turn off at the end of the cycle if there are no problems.
Before you start, it is a good idea to go through the following checklist:
1 Has the packaging been removed?
2 Is the machine correctly levelled, and the cabinet corners clear of the floor and walls?
3 Are the water tank, condenser filter and lint filter correctly in place?
4 Has the power cord been connected to an appropriate power supply and the power turnedon?
5 Have you performed the installation test cycle?
6 If external draining is preferred, is the drain hose attached to the correct outlet and hooked
into a standpipe or tub?
Loading ...
Loading ...
Loading ...