Loading ...
Loading ...
Loading ...
15
ENGLISH
9. Aftercare
The PV1D cabinet surfaces will usually only require
dusting. We recommend you use the cloth supplied
with the product. If you wish to use an aerosol or other
cleaner, apply the cleaner onto the cloth, not directly
onto the product and test a small area rst, as some
cleaning products may damage some of the surfaces.
Avoid products that are abrasive, or contain acid, alkali
or anti-bacterial agents. Do not use cleaning agents
on the drive units. Avoid touching the drive units as
damage may result.
To guard against unwanted or accidental
changes to settings or if they become otherwise
corrupted, there are two methods of recovery.
If you are using SubApp™, the current settings may
be saved into an XML le for later recovery and re-
programming of the PV1D. Alternatively they may be
stored in an additional internal memory area of the
PV1D using the following procedure:
i. With the PV1D in Standby mode (Standby
indicator is red), press and hold the logo on/
standby button until the indicator ashes (after
approximately 5 seconds). The navigation buttons
will also light up. Release the button.
ii. Press and hold the button until the indicator
ashes. Release the button.
iii. Press and hold the button until the indicator
ashes. Release the button.
iv. The indicator will switch to white while the
PV1D settings are stored and switch to red
(normal Standby mode) again when the process
is complete.
Note:Duetomemorylimitations,thisbutton
sequencewillnotsavePresets3-5.Allpreset
informationmaybesavedusingtheXMLle
method.
Restoring saved settings
i. With the PV1D in Standby mode (Standby
indicator is red), press and hold the logo on/
standby button until the indicator ashes (after
approximately 5 seconds). Release the button.
ii. Press and hold the button, again until the
indicator ashes. Release the button.
iii. The indicator will switch to white while the
PV1D settings are restored and switch to red
(normal Standby mode) again when the process
is complete.
Restoring factory default settings
i. With the PV1D in Standby mode (Standby
indicator is red), press and hold the logo on/
standby button until the indicator ashes (after
approximately 5 seconds). Release the button.
ii. Press and hold the button, again until the
indicator ashes. Release the button.
iii. The indicator will switch to white while the PV1D
settings return to their defaults and switch to red
(normal Standby mode) again when the process is
complete.
10. Storing current settings 11. Restoring settings
Loading ...
Loading ...
Loading ...