Loading ...
Loading ...
Loading ...
96 Servicing Your Honda
Drive Chain
1. Check the chain slider (1) for wear. If the wear
is 3/16 in (5 mm) or more, replace it.
2. Check the chain guide slider (2) for wear.
Replace the chain guide slider if it is worn to
the bottom of the wear limit groove (3).
1. Measure the diameter of the drive chain rollers.
Replace them if below the service limit.
Service Limit:
UPPER ROLLER: 1.1 in (29 mm)
LOWER ROLLER: 1.2 in (31 mm)
2. Replace the roller if necessary as follows.
Install the upper drive chain roller (Green) (1)
and lower drive chain roller (Black) (2) as
shown.
Tighten the drive chain roller bolt and nut to
the specified torque.
Upper roller bolt: 9 lbf·ft (12 N·m, 1.2 kgf·m)
Lower roller nut: 9 lbf·ft (12 N·m, 1.2 kgf·m)
Lubricate the drive chain with Pro Honda HP
Chain Lube or an equivalent chain lubricant or
drive chain lubricant designed specifically for use
with O-ring chains. Wipe off the excess oil or
chain lubricant.
Commercial chain lubricants not designed for
motorcycle drive chains may contain solvents
which could damage the O-rings.
Drive Chain Sliders
(1) chain slider
(2) chain guide slider
(3) wear limit groove
(1)
(2)
(3)
Drive Chain Rollers
(1) upper drive chain roller (2) lower drive chain roller
(1)
(2)
Lubrication
Loading ...
Loading ...
Loading ...