Loading ...
Loading ...
Loading ...
15
3 Set the measured water hardness with the rotary
selector. The value 12is set by default.
4 Confirm with ™.
Completing initial set-up
"Initial set-up complete. Please calibrate the appliance
before first cooking" appears in the display.
Confirm with ™.
The appliance enters the standby mode and the standby
display appears. The appliance is now ready for
operation.
Calibrate the appliance before steaming for the first
time. The appliance sets the boiling point.
Calibrating
The boiling point of water depends on barometric
pressure. As air pressure drops with increasing
elevation, the boiling point drops as well. During
calibration, the appliance sets the boiling point to the
pressure conditions at the place where it is installed.
It is important for the appliance to steam for 20 minutes
at 212° F (100°C) without interruption. Do not open the
appliance door during this time.
Notes
‒ Calibrate the appliance only when it is cold.
‒ During calibration, the appliance generates more
steam than it normally would do.
1 Set the program selection to S.
2 Select "Factory setting" with the rotary selector.
3 Touch the ™ symbol.
4 Select "Calibration" with the rotary selector.
5 Touch the % symbol.
6 Fill the water tank with cold water and touch the ™
symbol.
7 Remove all accessories from the oven interior and
touch the ™ symbol.
8 The duration of 20.00minutes appears. Start
calibration with I.
Calibration begins. The elapsing time is shown on the
display.
Note: Do not interrupt calibration. Do not change the
program selection. Do not open the appliance door.
A message appears in the display once calibration has
ended. Confirm with ™ and turn the program selection
to 0.
After a removal
Repeat calibration so that the appliance will
automatically adapt again to the new location.
After resetting to factory settings
After resetting to factory settings in the basic settings
menu the appliance has to be recalibrated.
After a power failure
The appliance saves the calibration settings, even after
a power failure or a disconnection from the mains. It
need not be recalibrated.
:DWHUKDUGQHVV
,QLWLDOVHWXSFRPSOHWH
3OHDVHFDOLEUDWHWKHDSSOLDQFH
EHIRUHILUVWFRRNLQJ
&DOLEUDWLRQ
&$/
&$/
Loading ...
Loading ...
Loading ...