Loading ...
Loading ...
Loading ...
54
Step 4. Console mast, brake lever and handle bar assembly
• Locate the console mast cover (31) and route the computer and hand
pulse cables (266, 269, 272) and the brake lever & cable (246) through
the cover. Temporarily place the cover down on the main body of the
bike. Do not snap the cover in place yet.
• Unravel the computer and hand pulse cables (266, 269, 272) and snake
them through the Console Mast (2) until the cables exit the top open-
ing of the console mast. Be sure the brake cable (133) is in the groove
of the cover when installing the mast during the next step.
• Holding the console mast in one hand, and gently keeping tension on
the cables at the top of the mast with the other, install the Console
Mast (2) into the Main Frame receiving tube under the cover (31). Keep-
ing tension on the cables will ensure the wires don’t get caught
between the mast and receiving tube. Do not bolt the mast in place at
this time
• Install the brake lever assembly (246) on the mast with the two 6mm
Phillips screws (98). Install the covers (275) with the four 4mm screws
(187). The top screws need to be tightened with the short screw driver.
• Slide the mast cover (31) up the mast and bolt the mast in place with
six 5/16” x 5/8” Hex Head bolts (68), four 5/16” Flat Washers (76) on
the side bolts, and two 5/16” Curved Washers (83) on the front bolts.
Slide the cover down and snap in place on the main body.
• Assemble the handle bar to the mast with two 5/16” x 5/8” bolts (68),
two 5/16” split washers (82) and two 5/16” at washers (76).
Loading ...
Loading ...
Loading ...