Loading ...
Loading ...
Loading ...
24
Installing the water heater
During Installation of this water heater...........
DO
❑ DO check inlet gas pressure to
ensure that it is within the range
specified on the rating plate.
❑ DO maintain proper
clearances to combustibles as
specified on the rating plate.
❑
DO
allow enough time for joint
cement vapors to dissipate BEFORE
applying power to the water heater.
❑
DO
ensure that the venting
system complies with the guidelines
found in the Use and Care Manual
and National Fuel Gas Code.
❑
DO
contact a qualified service
technician if the main burner will
not stay lit. The burner chamber
is designed to be sealed utilizing a
gasket and tamper resistant screws.
❑
DO
provide proper slope for
condensate drain line.
DON’T
❑ DON’T block the Flammable
Vapor Sensor located around the
lower portion of the water heater
jacket.
❑ DON’T remove the Burner
Access Door unless absolutely
necessary. This should only
be done by a qualified service
technician. A new burner access
door gasket must be installed on
any burner access door that has
been removed.
❑ DON’T install this water
heater where standing water may
occur. The base of the water
heater is meant to be mounted on
a dry surface.
❑ DON’T allow cleaners,
solvents, or other materials
to come into contact with the
Flammable Vapor Sensor.
❑ DON’T operate the water
heater if the sight glass or burner
access door grommet is damaged
or broken (see illustration at left).
Burner Access
Door Grommet
Sight Glass
Flammable
Vapor
Sensor
Loading ...
Loading ...
Loading ...