Loading ...
Loading ...
Loading ...
53
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSES WHAT TO DO
Cycle time
longer than usual
/ inaccurate
adjustment of
time remaining
during cycle
Cycle time is approximate. Cycle time is influenced by a number of factors
refer to ‘Wash cycles’.
Low water pressure or flowrate. Ensure that inlet hose filters are notblocked.
Out of balance or oversudsing. Recovery from out of balance or oversudsing
will extend cycle time refer to ‘Caring for
your washer’.
Washing a large load. Be aware that it will take longer forthewasher
to fill.
Selecting various options. Be aware that some options will extend
cycle time.
Detergent or fabric
softener remaining
in dispenser at the
end of the cycle
Dispenser drawer not properly
closed or was opened part way
through the cycle.
Ensure the dispenser drawer is fully closed at the
start of the cycle and remains closed throughout
the cycle.
Dirty or blocked dispenser. Clean the dispenser drawer. Refer to ‘Cleaning the
detergent dispenser drawer’.
Liquid sitting at the MAX
level at the end of the cycle
indicates a blockage.
Clean the fabric softener dispenser compartment,
refer to ‘Cleaning the detergent dispenser drawer’.
Dispenser over loaded
with detergent.
Clean out remaining detergent, Refer to ‘Cleaning
the detergent dispenser drawer’.
Composition of the
powder detergent makes it
difficultto dispense.
Dissolve detergent with water to aid
with dispensing.
Washing very
wet at the end
of the cycle
Cycle selected not appropriate. Particularly short or delicate cycles have shorter
spins which can result in wetter washing at the
end of the cycle.
Incorrect spin speed for
load selected.
Select a faster spin speed.
An out of balance load
hasoccurred.
The washer compensates for the out of balance
by using a lower spin speed, to reduce noise and
potential damage to the product.
Vibrating Transit bolts left in place. Ensure transit bolts are removed prior touse
of the washer, refer to ‘Removing transit
safety bolts’.
Washer may not be level. Ensure washer is installed on an appropriate
surface and levelled correctly, refer to ‘Levelling
the washer’.
Load is out of balance. Wash an average sized load rather than asmaller
load or a single item. Washingone item at a
time is not recommended as it is difficult for the
washer to balance a single item duringspin.
Loading ...
Loading ...
Loading ...