Loading ...
Loading ...
Loading ...
www.LaViewSecurity.com38
FAQ
No image displayed on the monitor after
starting up normally.
Possible Reasons
a) NoVGAorHDMIconnections.
b) Connection cable is damaged.
c) Input mode of the monitor is incorrect.
Steps
1. Verify the device is connected to the
monitorviaHDMIorVGAcable.
Ifnot,pleaseconnectthedevicewiththe
monitor and reboot.
2. Verify the connection cable is good.
If there is still no image display on the
monitorafterrebooting,pleasecheckifthe
connectioncableisgood,andchangeacable
to connect again.
3. Verify Input mode of the monitor is
correct.
Please check the input mode of the monitor
matches with the output mode of the device
(e.g. if the output mode of DVR is HDMI
output,thentheinputmodeofmonitor
mustbetheHDMIinput).Andifnot,please
modify the input mode of monitor.
4. Check if the fault is solved by the step 1
to step 3.
Ifitissolved,nishtheprocess.
Ifnot,pleasecontacttheengineertodothe
further process.
There is an audible warning sound “Di-Di-
Di-DiDi” after a new bought DVR starts up.
Possible Reasons
a) NoHDDisinstalledinthedevice.
b) TheinstalledHDDhasnotbeen
initialized.
c) TheinstalledHDDisnotcompatible
withtheDVRorisbroken-down.
Steps
1. Verify at least one HDD is installed in
the DVR.
1) Ifnot,pleaseinstallthecompatible
HDD.
Note: Pleaserefertothe“Quick
OperationGuide”fortheHDD
installation steps.
2) Ifyoudon’twanttoinstallaHDD,
select“Menu>Conguration>
Exceptions”,andunchecktheAudible
Warningcheckboxof“HDDError”.
2. Verify the HDD is initialized.
1) Select“Menu>HDD>General”.
2) If the status of the HDD is
“Uninitialized”,pleasecheckthe
checkboxofcorrespondingHDDand
clickthe“Init”button.
3. Verify the HDD is detected or is in good
condition.
1) Select“Menu>HDD>General”.
2) If the HDD is not detected or the
statusis“Abnormal”,pleasereplace
the dedicated HDD according to the
requirement.
4. Check if the fault is solved by the step
1 to step 3.
1) Ifitissolved,nishtheprocess.
2) Ifnot,pleasecontacttheengineertodo
the further process.
The status of the added IPC displays
as “Disconnected” when it is connected
through Private Protocol. Select
“Menu>Camera>Camera>IP Camera” to
get the camera status.
Possible Reasons
a) Networkfailure,andtheDVRandIPC
lost connections.
b) Theconguredparametersareincorrect
when adding the IPC.
c) Insucientbandwidth.
Steps
1. Verify the network is connected.
Loading ...
Loading ...
Loading ...