Loading ...
Loading ...
Loading ...
5
INSTALLING YOUR APPLIANCE
General Installation
Leveling Information
1.
unit is level. Level should be
placed along top edge and
side edge as shown.
2. If the unit is not level, adjust the legs on the corners of
the unit as necessary.
3.
repeat the previous steps as needed.
1
Figure 3
Figure 4
-
ing, adjust the rear legs to achieve a total unit rear height of
¹” (3 mm) less than opening’s rear height. Shorten the unit
height in the front by adjusting the front legs. This allows
the unit to be gently tipped into the opening. Readjust the
front legs to level the unit after it is correctly positioned in
the opening.
Installation
1. Plug in the power/electrical cord.
2. Gently push the unit into position. Be careful not to
entangle the cord or water and drain lines, if applicable.
3. Re-check the leveling, from front to back and side to
side. Make any necessary adjustments. The unit’s top
countertop.
4. Install the anti-tip bracket.
5. Remove interior packing material and wipe out the
inside of the unit with a clean, water-dampened cloth.
NOTE
Loading ...
Loading ...
Loading ...