Loading ...
Loading ...
Loading ...
10
Water Hookup
PREPARE PLUMBING
The water valve uses a standard 1/4” (6.35 mm)
Plumbing installation must observe all state and local
codes. All water and drain connections MUST BE made by
recommendations and instructions may result in damage
and/or harm.
Water Supply Connection
When connecting the water supply, please note the
following:
• Before installing the unit and connecting to the cold
water supply, review the local plumbing codes.
• The water pressure should be between 20 and 120 psi
(138 and 827 kPa).
•
supply line.
• The water line should be looped into 2 coils. This will
allow the unit to be removed for cleaning and servicing.
Make certain that the tubing is not pinched or damaged
during installation.
Do not use any plastic water supply line. The line is under
pressure at all times. Plastic may crack or rupture with age
and cause damage to your home.Do not use tape or joint
line that includes a rubber gasket. The gasket provides
an adequate seal – other materials could cause blockage
of the valve.Failure to follow recommendations and
void the product warranty.Use new hose set. Do not reuse
old hose set.
unit prior to installation. Use caution when handling back
panel. The edges could be sharp.
INSTALLING THE WATER SUPPLY
!
CAUTION
!
CAUTION
MLCR215, MACR215 & MOCR215
product prior to attempting installation.
2. Remove the back panel.
3. Locate water valve inlet.
5. Thread water line through back panel hold (with
bushing).
6. Locate water valve inlet and connect to valve.
7. Turn on water supply and check for leaks.
8. Reinstall back panel.
9. Install retaining clip.
!
CAUTION
Figure 10
Figure 13
Figure 12
Figure 11
Loading ...
Loading ...
Loading ...