Loading ...
Loading ...
Loading ...
16
Anti-Tip Bracket
1. Slide unit out so screws on top of unit are easily
accessible.
2. Remove the two screws from the opposite side of the
hinge assembly using a T-25 Torx driver (see below).
3. Place bracket over holes and attach to unit with two
screws removed in step 2 using a T-25 Torx driver.
Tighten screws fully.
4. Gently push unit into position. Be careful not to entangle
the electrical cord or water line, if applicable.
5. Check to be sure the unit is level from front to back and
side to side. Make any necessary adjustments. The
unit’s top surface should be approximately ¹” (3 mm)
below the countertop.
6. Secure bracket onto adjoining surface.
Figure 32
Figure 33
INSTALLING THE ANTI-TIP DEVICE
Loading ...
Loading ...
Loading ...