Loading ...
Loading ...
Loading ...
17
PANEL INSTALLATION - MLCR215-IS01A
1. Fully open door.
2. Starting at corner, pull gasket away
from door.
3. Continue to pull gasket free from
gasket channel.
4. Upon removal, lay gasket down on a
5. Align top of panel with top edge of door. Center panel
on door.
Figure 34
Figure 35
NOTE
door.
Figure 36
6. Secure overlay panel to door using
clamps. A robust tape may also be used.
Marvel recommends the use of bar
clamps to secure the panel to the door.
If using tape, be certain the tape will not
7. Using a 7/64” (3 mm) drill bit, drill 6
pilot holes into the wood panel 1/2” (12
mm) deep using the holes in the door
frame as a guide.
Figure 37
It is important to ensure that all drilled holes are drilled
to the correct depth in order to avoid splits in the wood
when hardwood is installed.
8. Locate 6 of the #6x 1-1/4” (32 mm) screws provided with
your unit.
9. Using a Phillips screwdriver, place one screw into each
of the 6 pilot holes and screw down. Do not over tighten
screws.
10. Be sure the screws force their way past the opening on
channel.
Figure 38
11. Remove clamps from door.
If panel requires additional adjustment after removing
clamps, slightly loosen each screw and adjust panel as
necessary. Tighten screws upon completion.
12. Starting at the corners, reinstall the gasket into the
gasket channel in the frame. Make sure the gasket is fully
seated. This make take some force.
NOTE
Loading ...
Loading ...
Loading ...