Loading ...
Loading ...
Loading ...
19
INSTALLATION
ENGLISH
Use sealant tape or sealing compound on the
tap’s thread to avoid water leaks.
Make sure that the line is not kinked or sharply
bent.
NOTE
Before connecting the water supply hose to the
tap, turn on the tap to flush out foreign
substances (dirt, sand or sawdust) in the water
lines. Let water drain into a bucket.
It takes about 3 – 4 minutes for the first supply
water.
Routing Electrical Wiring
Connect the appliance to an earthed socket in
accordance with the current wiring regulations,
protected by a minimum 15 amp circuit breaker or
time delay fuse.
Wiring must be two wires with earth.
The power cord should not be positioned behind
the appliance but within 1.2 meters of the side so
that the plug is easily accessible.
WARNING
For personal safety, remove house fuse or open
circuit breaker or switch off power plug before
installation.
Do not use an extension cord or double adapter.
The plug must be plugged into an appropriate
outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
Repairs to the appliance must only be carried out
by qualified service personnel. Repairs carried
out by inexperienced persons may cause injury
or serious malfunctioning. Contact our local
service centre.
Connect to a properly rated, protected, and sized
power circuit to avoid electrical overload.
Final Installation Check
Testing the Dishwasher
1
Turn on electrical power.
2
Turn on house water supply.
3
The door should open and close smoothly and
without harsh noises, if the unit has been
levelled correctly.
4
Run the appliance on a
Rinse
cycle to verify
proper operation and check for leaks.
Installation Check Error Codes
Error
Code
Possible Cause and Solution
OE
Drain hose kinked or pinched.
Feed the drainage and supply
hoses through the hole under
the sink. Then gradually slide the
dishwasher into the cabinet
while pulling on the hoses under
the sink to take up any slack. This
helps avoid kinking the hoses or
trapping them beneath the
dishwasher.
Waste spigot under sink is
clogged.
Drill out the waste spigot under
the sink.
Loading ...
Loading ...
Loading ...