Loading ...
Loading ...
Loading ...
Headlight Time Delay
This feature provides the safety of headlight
illumination for up to 90 seconds when leaving
your vehicle in an unlit area with the headlight
switch in the O (off) position.
To activate the delay feature, turn OFF the
ignition switch while the headlights are still on.
Then, turn off the headlights within 45 sec-
onds. The delay interval begins when the head-
light switch is turned off.
NOTE:
The lights must be turned off within 45 seconds
of turning the ignition OFF to activate this fea-
ture.
If you turn the headlights, park lights or ignition
switch ON again, the system will cancel the
delay.
If you turn the headlights off before the ignition,
they will turn off in the normal manner.
NOTE:
The Headlight Time Delay is programmable us-
ing the Uconnect System, refer to “Uconnect
Settings” in “Multimedia” in your Owner’ s
Manual for further information.
Fog Lights — If Equipped
The front fog light switch is built into the head-
light switch.
To activate the front fog lights, turn on the
parking lights or the low beam headlights and
push the headlight switch. To turn off the front
fog lights, either push the headlight switch a
second time or turn off the headlight switch.
An indicator light in the instrument cluster dis-
play illuminates when the fog lights are turned
on.
NOTE:
The fog lights will operate with the low beam
headlights or parking lights on. However , select-
ing the high beam headlights will turn off the
fog lights.
Turn Signals
Move the multifunction lever up or down and
the arrows on each side of the instrument clus-
ter display flash to show proper operation of the
front and rear turn signal lights.
NOTE:
• If either light remains on and does not flash,
or there is a very fast flash rate, check for a
defective outside light bulb. If an indicator
fails to light when the lever is moved, it would
suggest that the indicator bulb is defective.
• A “Turn Signal On” message will appear in the
instrument cluster display and a continuous
chime will sound if the vehicle is driven more
than 1 mile (1.6 km) with either turn signal
on.
WINDSHIELD WIPERS AND
WASHERS
The multifunction lever operates the windshield
wipers and washer when the ignition is placed in
the ON/RUN or ACC position. The multifunction
lever is located on the left side of the steering
column.
Wiper Operation
Rotate the end of the multifunction lever to the
first detent, past the intermittent settings for
low-speed wiper operation, or to the second
detent past the intermittent settings for high-
speed wiper operation.
GETTING TO KNOW YOUR VEHICLE
30
Loading ...
Loading ...
Loading ...