Loading ...
Loading ...
Loading ...
STARTING THE ENGINE
Before starting your vehicle, adjust your seat,
adjust the inside and outside mirrors, fasten
your seat belt, and if present, instruct all other
occupants to buckle their seat belts.
WARNING!
• When exiting the vehicle, always make
sure the ignition is in “OFF” mode, remove
the key fob from the vehicle and lock the
vehicle.
• Never leave children alone in a vehicle, or
with access to an unlocked vehicle. Leav-
ing children in a vehicle unattended is
dangerous for a number of reasons. A child
or others could be seriously or fatally in-
jured. Children should be warned not to
touch the parking brake, brake pedal or the
transmission gear selector.
• Do not leave the key fob in or near the
vehicle (or in a location accessible to chil-
dren), and do not leave the ignition (of a
vehicle equipped with Keyless Enter-N-Go)
in the ACC or ON/RUN mode. A child could
WARNING!
operate power windows, other controls, or
move the vehicle.
• Do not leave children or animals inside
parked vehicles in hot weather . Interior
heat build-up may cause serious injury or
death.
Normal Starting
To Turn On The Engine Using The ENGINE
START/STOP Button — Manual Transmission
Only
1. Press and hold the clutch pedal while push-
ing and holding the ENGINE ST ART/STOP
button.
2. Release the button when the engine starts. If
the vehicle fails to start within 15 seconds,
release the button, wait 10 to 15 seconds,
then repeat the “Normal Starting”
procedure.
3. If you wish to stop the cranking of the engine
prior to the engine starting, release the
button.
NOTE:
Normal starting of either a cold or a warm
engine is obtained without pumping or pressing
the accelerator pedal.
To Turn On The Engine Using The ENGINE
START/STOP Button — Automatic Transmis-
sion Only
1. The transmission must be in P ARK.
2. Press and hold the brake pedal while push-
ing the ENGINE START/STOP button once.
3. The system takes over and attempts to start
the vehicle. If the vehicle fails to start, the
starter will disengage automatically after
10 seconds.
4. If you wish to stop the cranking of the engine
prior to the engine starting, push the button
again.
NOTE:
Normal starting of either a cold or a warm
engine is obtained without pumping or pressing
the accelerator pedal.
111
Loading ...
Loading ...
Loading ...