Loading ...
Loading ...
Loading ...
To decrease the distance setting, push the Dis-
tance Setting — Decrease button and release.
Each time the button is pushed, the distance
setting decreases by one bar (shorter).
General Information
The following regulatory statement applies to all
Radio Frequency (RF) devices equipped in this
vehicle:
This device complies with Part 15 of the FCC
Rules and with Industry Canada license-exempt
RSS standard(s). Operation is subject to the
following two conditions:
1. This device may not cause harmful
interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE:
Changes or modifications not expressly ap-
proved by the party responsible for compliance
could void the user’ s authority to operate the
equipment.
PARKSENSE REAR PARK ASSIST —
IF EQUIPPED
The ParkSense Rear Park Assist system pro-
vides visual and audible indications of the dis-
tance between the rear fascia and a detected
obstacle when backing up, e.g. during a parking
maneuver.
Refer to “ParkSense System Usage Precau-
tions” in “Starting And Operating” in your Own-
er’s Manual for limitations of this system and
recommendations.
ParkSense will retain the last system state (en-
abled or disabled) from the last ignition cycle
when the ignition is changed to the ON/RUN
position.
ParkSense can be active only when the gear
selector is in REVERSE. If ParkSense is enabled
at this gear selector position, the system will
remain active until the vehicle speed is in-
creased to approximately 7 mph (11 km/h) or
above. The system will become active again if
the vehicle speed is decreased to speeds less
than approximately 6 mph (9 km/h).
ParkSense Sensors
The four ParkSense sensors, located in the rear
fascia/bumper, monitor the area behind the ve-
hicle that is within the sensors’ field of view. The
sensors can detect obstacles from approxi-
mately 12 inches (30 cm) up to 79 inches (200
cm) from the rear fascia/bumper in the horizon-
tal direction, depending on the location, type
and orientation of the obstacle.
Enabling And Disabling ParkSense
ParkSense can be enabled and disabled with
the ParkSense switch, located on the switch
panel below the Uconnect display.
When the ParkSense switch is
pushed to disable the system, the
instrument cluster will display the
“ParkSense Off” message for ap-
proximately five seconds. When the gear selec-
tor is moved to REVERSE and the system is
disabled, the instrument cluster display will
display the “ParkSense Off” message for as long
as the vehicle is in REVERSE.
Refer to “Instrument Cluster Display” in “Get-
ting To Know Y our Instrument Panel” in your
Owner’s Manual for further information.
127
Loading ...
Loading ...
Loading ...