Loading ...
Loading ...
Loading ...
2. Connect the Power Plug (8) to a different
12 V olt power outlet in your vehicle or an-
other vehicle, if available. Make sure the
engine is running before turning ON the Tire
Service Kit.
3. The Sealant Bottle (1) may be empty due to
previous use. Call for assistance.
NOTE:
If the Mode Select Knob (5) is on Air Mode and
the pump is operating, air will dispense from
the Air Pump Hose (7) only, not the Sealant
Hose (6).
If the sealant (white fluid) does flow through the
Sealant Hose (6):
1. Continue to operate the pump until sealant
is no longer flowing through the hose (typi-
cally takes 30 - 70 seconds). As the sealant
flows through the Sealant Hose (6), the Pres-
sure Gauge (3) can read as high as 70 psi
(4.8 Bar). The Pressure Gauge (3) will de-
crease quickly from approximately 70 psi
(4.8 Bar) to the actual tire pressure when the
Sealant Bottle (1) is empty.
2. The pump will start to inject air into the tire
immediately after the Sealant Bottle (1) is
empty. Continue to operate the pump and
inflate the tire to the pressure indicated on
the tire pressure label on the driver -side
latch pillar (recommended pressure). Check
the tire pressure by looking at the Pressure
Gauge (3).
If the tire does not inflate to at least 26 psi
(1.8 Bar) pressure within 15 minutes:
• The tire is too badly damaged. Do not attempt
to drive the vehicle further . Call for assistance.
NOTE:
If the tire becomes overinflated, push the Defla-
tion Button (2) to reduce the tire pressure to the
recommended inflation pressure before con-
tinuing.
If the tire inflates to the recommended pressure
or is at least 26 psi (1.8 Bar) pressure within
15 minutes:
1. Push the Power Button (4) to turn off the Tire
Service Kit.
2. Remove the Speed Limit sticker from the top
of the Sealant Bottle (1) and place the
sticker on the instrument panel.
3. Immediately disconnect the Sealant Hose
(6) from the valve stem, reinstall the cap on
the fitting at the end of the hose, and place
the Tire Service Kit in the vehicle storage
location. Quickly proceed to (D) “Drive
V ehicle.”
CAUTION!
• The metal end fitting from Power Plug (8)
may get hot after use, so it should be
handled carefully.
• Failure to reinstall the cap on the fitting at
the end of the Sealant Hose (6) can result
in sealant contacting your skin, clothing,
and the vehicle’s interior . It can also result
in sealant contacting internal Tire Service
Kit components which may cause perma-
nent damage to the kit.
(D) Drive Vehicle:
Immediately after injecting sealant and inflat-
ing the tire, drive the vehicle 5 miles (8 km) or
ten minutes to ensure distribution of the Tire
Service Kit Sealant within the tire. Do not ex-
ceed 50 mph (80 km/h).
149
Loading ...
Loading ...
Loading ...