Loading ...
Loading ...
Loading ...
PARKVIEW REAR BACK UP
CAMERA
Your vehicle is equipped with the ParkView Rear
Back Up Camera that allows you to see an
on-screen image of the rear surroundings of
your vehicle whenever the gear selector is put
into REVERSE. The ParkView camera is located
on the rear of the vehicle above the rear license
plate. The image will be displayed in the touch-
screen display along with a caution note to
“check entire surroundings” across the top of
the screen. After five seconds, this note will
disappear.
Manual Activation Of The Rear View Camera:
1. Press the "Controls" button located on the
bottom of the Uconnect display.
2. Press the "Backup Camera" button to turn
the Rear View Camera system on.
NOTE:
The ParkView Rear Back Up Camera has pro-
grammable modes of operation that may be
selected through the Uconnect System. Refer to
“Uconnect Settings” in “Multimedia” in your
Owner’s Manual for further details.
If your vehicle is equipped with the Camera
Delay feature and it is turned on, the rear cam-
era image will be displayed for up to 10 seconds
when the vehicle is shifted out of REVERSE.
However, this feature is canceled if the forward
vehicle speed exceeds 8 mph (13 km/h), the
transmission is shifted into PARK, the vehicle's
ignition is cycled to OFF, or by pressing the
image defeat [X] button.
When the vehicle is shifted out of REVERSE
(with Camera Delay turned off), the rear camera
mode is exited and the last touchscreen appears
again.
When enabled, active guide lines are overlaid on
the image to illustrate the width of the vehicle
and its projected backup path based on the
steering wheel position. The active guide lines
will show separate zones that will help indicate
the distance to the rear of the vehicle.
When manually activated, a counter will be
initiated after the vehicle speed is above 8 mph
(13 km/h). The rear view camera image will turn
off when this counter reaches 10 seconds. The
counter will be reset when the vehicle speed is
8 mph (13 km/h) or below.
If the vehicle speed remains below 8 mph
(13 km/h), the rear view camera image will
continue to be displayed until the transmission
is shifted into P ARK, the vehicle’s ignition is
cycled to the OFF position, or the image defeat
[X] button is pressed.
Different colored zones indicate the distance to
the rear of the vehicle.
WARNING!
Drivers must be careful when backing up
even when using the ParkView Rear Back Up
Camera. Always check carefully behind your
vehicle, and be sure to check for pedestrians,
animals, other vehicles, obstructions, or
blind spots before backing up. Y ou are re-
sponsible for the safety of your surroundings
and must continue to pay attention while
backing up. Failure to do so can result in
serious injury or death.
CAUTION!
• To avoid vehicle damage, ParkView should
only be used as a parking aid. The
STARTING AND OPERATING
128
Loading ...
Loading ...
Loading ...