Loading ...
Loading ...
Loading ...
24-02-2003
YOUR 206 IN DETAIL
90
AUTOMATIC SWITCHING ON
OF LIGHTS
Side lights and dipped beam head-
lamps switch on automatically if the
light is poor and when the wind-
screen wipers operate continuously.
They switch off when the light
becomes bright enough or the wind-
screen wipers are switched off.
Note: In foggy weather or in snow
the brightness sensor can detect
sufficient light. As a result, the lights
will not come on automatically.
This function is active when the
vehicle is supplied to the customer.
To disarm or activate the function:
– Start with the key in the acces-
sories position (1st notch),
– Press the end of the lights stalk
for more than four seconds.
Note: after the ignition is switched
off and depending on the brightness,
the lights remain on for about
45 seconds or until the vehicle is
locked.
The brightness sensor, coupled
with the rain sensor, is located
in the centre of the windscreen,
behind the interior mirror. It is
used for automatic switching on
of the lights.
Operating check
Activation
Acivation of this function is accom-
panied by an audible signal and the
message "Automatic lighting
active'' on the multifunction display.
Disarming
Disarming of the function is accom-
panied by an audible signal.
Note: the function is temporarily dis-
armed when the driver uses the
manual lighting controls.
If the brightness sensor does not
function correctly, the system acti-
vates the function (the lights come
on). The driver is alerted by an audi-
ble signal, accompanied by the mes-
sage "Automatic switching on of
lights faulty" on the multifunction
display.
Contact a PEUGEOT dealer to have
the system checked.
Loading ...
Loading ...
Loading ...