Loading ...
Loading ...
Loading ...
en Steam
22
Note: If the water tank runs out of water during cooking,
the appliance will continue cooking, but without steam
assistance. No indicator will appear on the display.
The cooking time has elapsed
A signal sounds and the start l stop symbol stops
lighting up. Combination mode has finished. Touch any
field to end the acoustic signal.
Changing the steam level
Touch the " field until the required level is selected in
the display.
Note: Touch the field multiple times switches through
the levels from the highest to the lowest level. After the
lowest level, the steam function is deactivated.
Touching again activates the steam function, starting
with the highest level.
Pausing the operation
1. Touch the start l stop field or open the appliance
door.
The operation is suspended and the
start l stop LED flashes.
2. Close the appliance door.
3. Touch the start l stop field.
The operation is continued and the start l stop LED
lights up.
Stopping the appliance from heating
Turn the function selector to the "Off" position.
The appliance will stop heating and all the settings will
be cleared.
Note: The fan may continue to run after the appliance
has been paused or stopped.
Filling the water tank
Filling the wa t e r tank
The water tank is located to the right behind the tank
cover, below the appliance door. Before starting an
operation with steam, open the tank cover and fill the
water tank with water.
Ensure that the water hardness range has been set
correctly. ~ "Basic settings" on page 28
:Warning – Risk of injury and fire!
Only fill the water tank with water. Do not pour any
flammable liquids (e.g. alcoholic drinks) into the water
tank. Due to hot surfaces, vapours from flammable
liquids may catch fire in the cooking compartment
(explosion). The appliance door may spring open. Hot
steam and jets of flame may escape.
Caution!
The appliance may become damaged due to the use of
unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(>40 mg/l) or other liquids.
Only use fresh, cold, non-carbonated tap water or
softened water.
Notes
■ If your water is very hard; we recommend that you
use softened water.
■ If you use only softened water, you can set your
appliance to the "softened" water hardness range.
1. Briefly press on the centre of the tank cover.
The tank cover will open. The drip tray (left) and
water tank (right) can now be accessed.
2. Remove the water tank from the tank recess.
3. Fill the water tank with cold water up to the "max."
mark.
4. Place the water tank back into the tank recess and
slide it in fully.
5. Close the tank cover.
The steam function is ready to use.
1 2
Loading ...
Loading ...
Loading ...