Loading ...
Loading ...
Loading ...
SHS800X&SHS1000X User Manual
25
WWW.SIGLENT.COM
Vertical Position
Press the Vertical Position button to adjust the vertical position of the channel
waveform. Press up to increase the vertical position and the channel waveform
moves up, while press down to decrease the vertical position and the waveform
moves down. Press the Shift and Vertical Position button to set the vertical
position of the channel waveform to zero.
The table below shows the range of vertical positions according to the volt scale.
Volt Scale
Range of Vertical Position
2 mV/div ~ 296 mV/div
±5 V
302 mV/div ~ 7.5 V/div
±80 V
7.6 V/div ~ 100 V/div
±400 V
Coupling
Set the coupling mode to filter out the undesired signals. For example, the signal
under test is a square waveform with DC offset.
When the coupling mode is set to
DC: the DC and AC components of the
signal under test can both pass through the channel.
When the coupling mode is set to AC: the DC components of the signal under
test are blocked.
When the coupling mode is set to GND: the DC and AC components of the
signal under test are both blocked.
Press the CH1 button on the front panel; then press the Coupling softkey and turn
the Universal Knob to select the desired coupling mode. The default setup is DC.
The current coupling mode is displayed in the channel information bar at the
bottom of the screen. You can also press the Coupling softkey continuously to
switch the coupling mode.
Loading ...
Loading ...
Loading ...