Loading ...
Loading ...
Loading ...
8
3
Setting Up
Your Snow
Thrower
9. It is important that all cables be routed through the
cable guide and remain positioned on the left side of
the hex rod. See Figure 3-10.
NOTE: An extension cord may be fastened with a
cable tie to the rear of the auger housing for shipping
purposes. Cut the cable tie and remove it before operat-
ing the snow thrower.
CAUTION: Prior to operating your snow thrower,
refer to Auger Control Test in the “Operating” sec-
tion. Read and follow all instructions carefully, and
perform all adjustments to verify your snow thrower
is operating safely and properly.
Clean-Out Tool
The clean-out tool is mounted to the rear of the auger
housing with a mounting clip and a cable tie at the
factory. Cut the cable tie before operating the snow
thrower. See Figure 3-11.
Shear Pin Storage (optional)
An area for convenient shear pin storage is located at
the rear of the dash panel.
Never use your hands
to clean snow and
ice from the chute
assembly or auger
housing.
Figure 3-10
Figure 3-11
Chute Clean-out Tool
Loading ...
Loading ...
Loading ...