Loading ...
Loading ...
Loading ...
20
Ping
The illuminator will respond to a standard Ping command sent to its valid IP address.
For the ping command to work the illuminator and computer must reside in the same
network range.
Basic Troubleshoot
• Check if the camera and illuminator are aligned correctly.
• For Infra-Red illumination, ensure that a Day and Night or Black and White
camera is used and that the camera switches correctly into night mode.
• Check camera and lens. Is iris fully open at night and set correctly. Ensure
camera is fully operational and has correct night time settings and capability.
• Ensure correct illuminator lens angle selected for required distance – check
stated performance.
• Check the LED status indicator: if green LED indicator is lit on the bottom of
the unit, then the unit is receiving power.
• Check voltage applied and that power supply is suitably rated for the VARIO2
IPunit – see page 6 for required ratings.
Check connection and wiring of CAT5 / 6 cable to VARIO2 IP. Verify link has
been established with the router / switch to which the illuminator is connected
.
• If the illuminators are correctly wired to the network, run the Raytec Discovery
Tool and try to discover the illuminator on the network.
If the illuminator is discovered and the “State” indicator is grey, this
indicates that there is no communications with the illuminator. Ensure IP
Address and Subnet Mask of computer and illuminator are set within the same
range. If not, alter IP address of illuminator or Enable DHCP on illuminator for
Loading ...
Loading ...
Loading ...