Loading ...
Loading ...
Loading ...
20
3.5.2: Install a New Condenser
1. If necessary, reattach the mounting brackets to each side of the condenser with the
Phillips screws and washers previously removed.
2. Ensure that the carriage bolts for mounting the condenser brackets are in place on
the bottom of the machine compartment.
3. Install the new condenser with brackets over the mounting studs and secure with the
nuts previously removed.
4. Install and solder the discharge and liquid lines to condenser.
5. Install and solder a new filter drier in the system.
6. Evacuate, charge to serial plate recommendation, and leak check the sealed system.
Slide out the bottom of the machine
compartment far enough to unsolder
condenser lines.
Condenser can be lifted away from bottom
assembly after following step 7 above.
NOTE: On machine compartments with LEFT
HAND SWING doors, a shield is added to
prevent the communication cable from being
drawn into the condenser coil. It is anchored
using the same nut which secures the condenser
mounting bracket.
The above bracket is used on LEFT HAND
SWING doors to anchor the back end of the
communication cable.
Loading ...
Loading ...
Loading ...