Loading ...
Loading ...
Loading ...
106
14.2: Main Control Board Access
Caution Disconnect the main power supply to the appliance. Failure to do
so could result in severe shock.
1. The main power board can be accessed as follows:
Remove the front toe grill.
Locate the control housing assembly. See below.
Use a Phillips screwdriver and remove the two screws securing the control housing
assembly to the machine compartment base.
The control housing can now be slid outward away from the machine compartment.
NOTE: the rear of the control housing assembly is slotted to lock into a mounting
tab on the cabinet base. When re-installing; care must be taken to ensure that the
board is locked into place without pinching any wire harness.
Secure the control housing using the Phillips screws previously removed.
Replace the toe grill and secure.
2. The user interface functions the same as the other Aurora control systems.
See Sections 6 and 9 for reference.
3. Operating functions and navigation for the user interface can be reviewed in section 5.
Remove the four screws from the front of
the coil cover to remove either fan.
Loading ...
Loading ...
Loading ...