Loading ...
Loading ...
Loading ...
219
19.4.10.2 Evaporator Installation
1. Straighten out the tubing on the new assembly so that it can be installed.
2. Slide the tubing inside the ice machine and outward through the bun hole.
3. Bend the suction tubing outside the machine by thumb, taking care not to kink the
lines.
4. Carefully extend the tubing down the back of the machine and route tubing as was
the previous assembly.
5. Install a new filter drier.
6. Remove caps from tubing and solder lines into place.
7. Place insulation back into bun holes.
8. Screw evaporator back into place using the 4 pan head screws.
Hot gas line disconnect
Suction line disconnect
Evaporator heat
exchanger assembly
Loading ...
Loading ...
Loading ...