Loading ...
Loading ...
Loading ...
RIGOL Chapter 3 Remote Control
User’s Guide for DSA700 Series
3-8
5) Communication test
Right click the resource name such as
DSA710 (USB0::0x1AB1::0x0960::DSA8A134400008::INSTR)
and select SCPI Panel Control to open the remote control panel from
which you can write commands and read data. For detailed information
about SCPI commands, refer to
DSA700 Programming Guide
.
2. Remote Control via LAN
1) Connect the devices
Connect the analyzer to your LAN.
2) Configure LAN parameters
Select LAN interface according to the description in "LAN" of "I/O
Settings".
3) Search device resource
Start-up Ultra Sigma and click
. Then, click in
the pop-up window and the software starts searching for the analyzer
resources connected to LAN. When a LAN resource is found, its name will
be displayed in the resource box on the right side of the panel. Select the
desired resource and click
to add the resource.
Note: The resource selected should keep consistency with the IP address
of the LAN interface of the spectrum analyzer. In addition, if you want to
remove the unwanted resource, click the corresponding resource name
and click
.
Loading ...
Loading ...
Loading ...