Loading ...
Loading ...
Loading ...
INSTALLATION
DESIGNED & BUILT IN USA
PROFESSIONAL COOKING EQUIPMENT
13592 Desmond St., Pacoima, CA 91331 818.897.0808 tel 888.753.9898 toll free www.americanrange.com
17
WARNING
!
WARNING
!
WARNING
!
Follow all safety instructions in this manual.
Failure to do so may result in re, electrical shock, personal injury and death.
It is recommended that electrical connections and wire sizes are adequate and in conformance with the National Electrical Code, ANSI/NFPA 70-latest edition or C22.1
Canadian Electrical Code Part1.
The oven must be connected to a main power supply with proper electrical voltage and amperage as specied in the Electrical Requirements or model/serial number rating
plate. The junction box located near the oven must be checked by a certied electrician or approved service technician for proper grounding and connections.
Disconnect power before installation or servicing. Check for proper grounding.
Failure to follow safety instructions can result in re, electrical shock and death.
Ovens are heavy and may need 2 or more people to move and install into the cabinet cutout. Appliance mover, with wheels or casters, is recommended to facilitate move-
ment of the appliance and prevent damage to oor surface.
Failure to follow safety precautions can result to back or other injury.
Ovens are heavy and may need 2 or more people to move and install into the cabinet cutout. Appliance mover, with wheels or casters, is recommended to facilitate
movement of the appliance and prevent damage to oor surface.
Failure to follow safety precautions can result to back or other injury.
MAKE ELECTRICAL CONNECTIONS
1. Disconnect power. Lock and tag-out.
2. Install junction box. For single & double oven cabinet installation, the junction
box location:
3. Move the oven with exible conduit/wires close to the cabinet cutout and
feed the wires and conduit through the rectangular cutout located at the rear
end of the cabinet cutout base.
4. Feed the wires in to the junction box and connect the conduit to the
junctions box using agency 1/2” conduit connector.
5. Connect the 2 black wires together using a UL listed wire connector.
6. Connect the 2 red wires together using a UL listed wire connector.
7. Connect the 2 white wires together using a UL listed wire connector.
8. Connect the solid copper wire to the green or bare ground wire with a
UL listed wire connector, or use the screw(s) in the grounded junction
box.
9. Install junction box cover.
Loading ...
Loading ...
Loading ...