Loading ...
Loading ...
Loading ...
INSTALLINGYOUR
REFRIGERATOR
%¸¸¸¸¸¸9¸¸¸
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
Removing Packaging Materials
• Remove tape and any labels from your refrigerator
before using (except the model and serial number
label).
To remove any remaining tape or glue, rub the area
briskly with your thumb. Tape or glue residue can also
be easily removed by rubbing a small amount of liquid
dish soap over the adhesive with your fingers. Wipe
with warm water and dry.
• Do not use sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners to remove tape or
glue. These products can damage the surface of your
refrigerator. For more information, see "Important Safety
Instructions" in the "Refrigerator Safety" section.
• On some models, shelves, bins, door shelf rails, and
other feature parts may be packaged in the Finishing
Touches TM FeaturePak. Follow the instructions
contained in the package for proper assembly.
IMPORTANT:
• Depending on your model, do not remove any
permanent instruction labels inside your refrigerator, or
the Tech Sheet that is fastened behind the base grille.
Depending on your model, do not remove the white
Styrofoam insert that is located behind the control panel
on the ceiling of the refrigerator. The insert is part of the
refrigerator and not part of the packing material. If the
insert is removed, ice may migrate down from the
freezer and cause icicles to form.
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion,
or fire.
• To ensure proper ventilation for your refrigerator, allow
for a 1" (2.5 cm) space on each side
• Allow 4" (10.2 cm) of space between overhead cabinets
and refrigerator top.
• Allow at least 3" (7.5 cm) between back of cabinet and
the wall.
4" (10.2 crn) ....
1" (2.5 cm)
If your refrigerator has an ice maker, make sure you
leave some extra space at the back for the water line
connections. The refrigerator can be flush against the
back wall if you do not have an ice maker installed.
• If the hinge side of the refrigerator is to be against a
wall, you might want to leave extra space so the door
can swing open.
• Level the refrigerator (See "Door Closing and
Alignment").
NOTE: Do not install the refrigerator near an oven, radiator,
or other heat source, nor in a location where the
temperature will fall below 40° F (5° C).
5
Loading ...
Loading ...
Loading ...