Husqvarna Z560X Zero-Turn Mower

Operator's Manual - Page 28

For Z560X.

PDF File Manual, 208 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Problem Cause
The cutting result is unsatisfacto-
ry.
The tire pressure is different on the right and left sides. Refer to
Tire pressure on
page 20
.
The blades are damaged.
The suspension of the cutting deck is not level.
The blades are blunt. Refer to
To examine the blades on page 22
.
The product is operated at too high forward or rearward speed. Refer to
To get a
good cutting result on page 15
.
The grass is long or wet. Refer to
To get a good cutting result on page 15
.
There is grass blockage in the cutting deck. Refer to
To clean the product on
page 18
.
Transportation, storage and disposal
Transportation
The product is heavy and can cause crush injuries.
Be careful when you load it onto or off a vehicle or
trailer.
Load the product in reverse on approved ramps of
a maximum operation angle of 10°. Do not lift the
product.
Use an approved trailer for transportation of the
product.
Make sure that you have knowledge of local
road traffic regulations before transportation of the
product in a trailer or on roads.
Stop the fuel supply of the product.
Lock the product with approved devices, such as
straps. Use tie-down points on the product. The
parking brake is not sufficient to lock the product
during transportation.
To tow the product
WARNING: Before you tow the
product, you must read and understand the
safety chapter. Refer to
Safety on page 6
.
Be careful when you tow the product.
Operate the product slowly when you tow the
product.
The breaking distance increases when you tow the
product. Make sure to decreases the speed in time.
For safe operation, do wide turns.
Do not tow near ditches, open water, and other
dangerous areas.
Storage
Prepare the product for storage at the end of the
season, and before more than 30 days of storage. If
you keep fuel in the fuel tank for 30 days or more, tacky
particles can cause blockage. This has a negative effect
on the engine function.
To prevent tacky particles during storage, add a
stabilizer. If alkylate gasoline is used, stabilizer is not
necessary. If you use standard gasoline, do not change
to alkylate gasoline. This can cause sensitive rubber
parts to become hard. Add stabilizer to the fuel in
the tank or in the container used for storage. Always
use the mixing ratios given by the manufacturer. Add
the stabilizer and run the engine for a minimum of 10
minutes.
WARNING: Do not keep the product
with fuel in the tank in an indoor location or
in locations with bad airflow. Risk of fire if
fuel fumes come near open flames, sparks,
or pilot lights in for example boilers, hot
water tanks and clothes dryers.
WARNING: Remove grass, leaves and
other flammable materials from the product
to decrease the risk of fire. Let the product
become cool before you put it in storage.
Clean the product. Refer to
To clean the product on
page 18
.
Remove unwanted materials from the cooling fan.
Repair paint damages to prevent corrosion.
Examine the product for worn or damaged parts and
tighten loose screws and nuts.
28
2173 - 002 - 22.08.2023
Loading ...
Loading ...
Loading ...