Husqvarna Z560X Zero-Turn Mower

Operator's Manual - Page 22

For Z560X.

PDF File Manual, 208 pages, Download pdf file

Loading ...
Loading ...
Loading ...
6. Turn the 2 outer blades to align with the cutting deck
front to rear.
7. Adjust the 2 rear nuts until the rear blade tips are set
1/8–3/8 in. / 3.2-9.5 mm higher in the rear than in the
front blade tips.
8. Measure the distances again to make sure that the
cutting deck has been adjusted correctly.
To adjust the neutral position
The neutral position must be adjusted if 1 of the 2 rear
wheels is turning while the parking brake is engaged.
1. Use a lifting device to lift up the rear part of the
product until the rear wheels are off the ground.
2. Put a stable object below the product and make sure
that the product cannot move forward or rearward.
3. Engage the parking brake.
4. Start the product.
5. Fold the seat forward.
6. Remove the pin from the front coupler and hold it.
7. Turn the hex nut by hand clockwise or
counterclockwise until the rear wheel is stationary.
8. Turn the hex nut in the same direction again and
stop when the rear wheel turns in the opposite
direction. Count the number of turns you do on the
hex nut.
9. Turn the hex nut in the opposite direction, ½ of the of
turns you counted in the step before.
10. Do adjustment for the other side if it is necessary.
To examine the blades
CAUTION: Damaged or incorrectly
balanced blades can cause damage to the
product. Replace damaged blades. Let an
approved service agent help you sharpen
and balance blunt blades.
Look at the blades to see if they are damaged and if
it is necessary to sharpen them.
To replace the blades
1. Remove the blade bolt.
2. Assemble the new blade with the side without
stamps in the direction of the cutting deck.
WARNING: Incorrect blade type
can cause objects to eject from the
cutting deck and cause serious injury.
Use only approved blades.
3. Attach the blade bolt. Torque the bolt to 90 ft-lb / 122
Nm.
To remove the deck belt
Park the product on level ground and engage the
parking brake before you do this task.
1. Set the cutting deck in the lowest position.
2. Remove the 2 belt covers.
3. Remove dirt and unwanted materials from around
the cutter housings and the cutting deck surface.
4. Push in the idler arm to decrease the tension on the
deck belt and carefully remove the deck belt from the
pulleys.
5. Remove the deck belt from the electric clutch on the
engine shaft.
To install the deck belt
1. Put the deck belt around the electric clutch pulley on
the engine shaft.
2. Put the deck belt around the pulleys on the cutting
deck.
22
2173 - 002 - 22.08.2023
Loading ...
Loading ...
Loading ...