Husqvarna Z560X Zero-Turn Mower

Operator's Manual - Page 11

For Z560X.

PDF File Manual, 208 pages, Download pdf file

Loading ...
Loading ...
Loading ...
All moving parts have stopped.
The ignition cables are removed from the
spark plugs.
WARNING: Fluid escaping under
pressure may have sufficient force to
penetrate skin and cause serious injury. If
fluid is injected into the skin, seek immediate
medical attention. Keep body and hands
away from pin holes or nozzles that eject
fluid under high pressure. If a leak occurs,
have the product immediately serviced by a
trained technician.
WARNING: The exhaust fumes from
the engine contain carbon monoxide, an
odorless, poisonous and very dangerous
gas. Do not run the product in closed spaces
or spaces with no sufficient air flow.
Keep the product in good working order. Replace
worn or damaged parts.
Use caution when servicing blades. Wrap the
blade(s) or wear gloves. Replace damaged blades.
Do not repair or alter blade(s).
If equipped, disconnect spark plug wire(s) and the
negative battery cable before making any repairs.
For best performance and safety, do maintenance
on the product regularly as given in the maintenance
schedule. Refer to
Maintenance schedule on page
16
.
Electrical shocks can cause injuries. Do not touch
the cables when the engine is on. Do not do a
function test on the ignition system with your fingers.
Let the product become cool before you do
maintenance near the engine.
The blades are sharp and can cause cuts. Wind
protection around the blades or use protective
gloves when you do work on the blades.
Do not turn the engine over if the spark plug or
ignition cable is removed.
Make sure that all nuts and bolts are tightened
correctly and that the equipment is in good condition.
Do not change the adjustment of governors. If the
engine speed is too high, the product components
can become damaged. Refer to
Technical data on
page 30
for highest permitted engine speed.
The product is approved only with the equipment
supplied or recommended by the manufacturer.
Operation
Introduction
WARNING: Before you operate the
product, you must read and understand the
safety chapter.
To operate the product for the first time
WARNING: Before you operate the
product for the first time, you must read and
understand this chapter.
Use a decreased throttle speed and a decreased
ground speed when you operate the product for the
first time.
Do not move the control levers to the fully forward
position or the fully reverse position during the initial
operation.
Learn how to operate the movement of the product
on a hard surface, for example concrete or asphalt,
before you operate the product on a lawn for the first
time.
To do before you operate the product
WARNING: Before you operate the
product, you must read and understand the
safety chapter.
WARNING: Before you operate the
product, you must make sure that there are
no stones or other objects in the work area
that can be thrown by the rotating blades.
Do the daily maintenance. Refer to
Maintenance
schedule on page 16
.
Make sure that there is sufficient fuel in the fuel tank.
Set the cutting height. Refer to
To set the cutting
height on page 13
.
To fill fuel
WARNING: Gasoline is very
flammable. Be careful and refuel outdoors,
refer to
Fuel safety on page 10
.
WARNING: The engine and the
exhaust system become very hot during
operation. Risk of burn injury. Let the engine
and the exhaust system become cool before
you fill fuel in the product.
WARNING: Do not use the fuel tanks
as support areas.
2173 - 002 - 22.08.2023 11
Loading ...
Loading ...
Loading ...