Loading ...
Loading ...
Loading ...
42
BEFORE YOU CALL
Self-Clean Problems
Problem Cause / Solution
Self clean does not work. Oven control not set properly. See “Self Clean” on page 31.
Oven racks discolored or
do not slide easily.
Oven racks left in oven cavity during self clean. Remove oven racks from
oven cavity before starting a self-clean cycle. Clean by using a mild abrasive
cleaner following manufacturer's instructions. Rinse with clean water, dry,
and replace in oven.
Soil not completely re-
moved after self clean.
Self clean was interrupted. Review instructions on “Self Clean” on page 31.
Excessive spills on oven bottom. Remove excessive spills before starting self
clean.
Failure to clean soil from the oven frame, the door liner outside the oven
door gasket, and the small area at the front center of the oven bottom.
These areas are not in the self-cleaning area, but get hot enough to burn on
residue. Clean these areas before starting the self-cleaning cycle. Burned-on
residue can be cleaned with a sti nylon brush and water or a nylon scrub-
ber. Be careful not to damage the oven gasket.
Other Problems
Problem Cause / Solution
Appliance is not level. If the floor is sagging or sloping, contact a carpenter to correct the situa-
tion.
Kitchen cabinet alignment may make range appear not level. Be sure cabi-
nets are square and have sucient room for appliance clearance.
Cannot move appliance
easily. Appliance must be
accessible for service.
Cabinets not square or are built in too tightly. Contact the builder or install-
er to make the appliance accessible.
Oven light does not work. Be sure the oven light is secure in the socket. See “Replacing the Oven
Light” on page 37
Loading ...
Loading ...