Loading ...
Loading ...
Loading ...
56-VOLT LITHIUM-ION ELECTRIC ZERO TURN MOWER — ZT4200S/ZT4200S-FC46
◾
Begin with a high cutting height and reduce it until the desired mowing result is attained. Grass over 6 inches (152
mm) long should be mowed twice, at successively lower cutting heights.
◾
To maintain a healthy lawn, cut off only one-third or less of the total length of the grass (Fig. 20). The average lawn
should be approximately 1-1/2 to 2 inches (38 – 51mm) long during cool months, and between 2 to 3-1/4 inches
(51 – 83 mm) long during hot months. For healthier and better-looking lawns, mow more often after moderate
growth.
◾
Do not cut wet grass. Mowing on wet surfaces can cause loss of control and the wheels to sink into the soft lawn.
Wet grass will stick to the underside of the deck and prevent proper bagging or mulching of the grass clippings.
◾
New or thick grass may require a narrower cut or a higher cutting height.
◾
Keep the mower deck and side discharge chute clean. Remove grass clippings, leaves, dirt, and any other
accumulated debris before and after each use. See section “CLEANING THE MACHINE” in this manual.
TIPS TO INCREASE RUN TIME
To get longer run time, please follow these guidelines:
◾
Use as many battery packs as available.
◾
Use the battery packs with higher amp-hour (Ah) rating.
◾
Cut no more than 1.5 inch (38 mm) of grass in one pass.
◾
Do not cut wet grass.
◾
Make sure the blades are sharp.
◾
Make sure that the underside of the deck is clean.
◾
Slow down the blade speed – Use the blade speed level 1 (ECO).
◾
Increase the driving speed – Use the driving speed setting 3 (Standard speed) or 4 (Max speed).
◾
Do not use the mulching plug.
◾
Do not charge external devices using USB port.
COLD WEATHER OPERATION
NOTICE: Under extreme cold weather, the blade motor and driving function may not start successfully due to the low
temperature protection. Please do not make repeated attempts which may damage the machine. Always store the mower
and batteries in warm environment. Restart the mower when it is warmed up. Recommended operating temperature is
32°F–104°F (0°C–40°C).
SLOPE OPERATION
See section “SLOPE SPECIFIC” in this manual for safety instructions before slope operation.
DANGER
: Slopes are a major factor related to tip-over and roll-over accidents that can result in severe injury or
death. Operation on slopes requires extra caution. If you feel uneasy on a slope, do not mow it. For your safety, do not
attempt to mow steep slopes greater than 15 degrees. Make a copy or cut out the slope guide image (Fig. 21) and use it
to determine if your slope is too steep for safe operation.
WARNING:
Depress the parking-brake pedal immediately in case any emergency occurs.
Loading ...
Loading ...
Loading ...