Loading ...
Loading ...
Loading ...
Picture 5
Picture 6
Picture 7
6
Installation
4 Door Opener Installation (Right side installation)
There are several methods of door opener installation,
following one of them is described.
First of all, make sure enough room for driver
installation, the distance between the end of the door
shaft and the wall should be 135mm at least (Attention:
this method only suitable for right side installation). For
specific installation, please refer to picture 5, picture 6,
picture.
4.1 Check carefully to see whether the U bolt on the left
side is tightly fixed on the door shaft.
4.2 Lift up the door, tie up the door firmly with a rope in
middle position.
4.3 Use support to sustain the right part of the door
curtain. (Attention: Something soft should be padded
under the support in case of door surface damage.)
Warning: During installation, children are forbidden to be
around, if ignore this warning, severe personal injury or
property loss may be caused.
4.4 Check if step 3 is finished, then release the U bolt
on the right side of the door and take it away carefully.
4.5 After right the door support removed from the wall,
please make sure that the support of the door is safe
and reliable.
4.6 Take out the opener from the package, manually
turn the forks on the opener to make the gear spin, if the
gear do not spin, it is considered as auto mode. At this
time, please draw the clutch handle (if ERD1006 draw
red clutch) manually and softly to take part the driving
gear and the motor to shift to manual operation mode,
in this case the gear can spin freely.
4.7 Push the opener along the door shaft to plastic
plate, and make sure that the double forks of the gear is
in the narrowest spoke and stretch into the plastic plate.
4.8 Reinstall the right side support, if special case, the
support frame should be relocated, and retighten the U
bolt, remove the support below the door and the
bundled rope.
4.9 Move the door up and down with the hands to see
if the door operates well. The door should move
smoothly and can not be touched.
Make sure that the U bolt is fixed firmly
Rope
Shear the rope
Remove the support
Reinstall
right side
support
frame
Refix the
U bolt
Support
Remove the U bolt
Remove the
right side
support frame
If the gear of
the driver can
not spin, please
draw the clutch
handle
Loading ...
Loading ...
Loading ...