Loading ...
Loading ...
Loading ...
Definition of Control Board
1 Function Setting Button (Set)
During installation, please set the upper and
lower limit, left and right installation, operating
power and auto closing time.
2 Remote control learn button (Code)
Add or delete code of transmitter.
3 Increase (Open) Button (▲ )
During installation，please set the button value
be Increase or Open.
4 Decrease (Close) Button (▼ )
During installation, please set the button value
Decrease or Close.
5 Open/Stop/Close Button (OSC)
The opener operates in the cycle of
Open-----Stop--------Close-----Stop.
6 Digital Display Menu
During the installation and using, the digital menu
displays current value and status.
7 Courtesy Light
Illumination and Fault Indicator.
8 Interface to Outside Wall Switch
This interface is available for wall switch or other
control devices, the opener operates in the
manner of Open-----Stop----Close----Stop.
9 Connector for Photo Beam Sensor
DC 24V Normally Closed Photo Beam Sensor
can be connected to this connector.
10 Input for Encoder Signal
To connect the inside encoder.
11 Motor Power Output
Connect to inside DC motor
12 Backup Battery Input
Can connect DC 24V back up battery.
13 Transformer Power Input
Input AC 24V transformer power.
14 24V Power Supply Fuse
T15A/250V Fuse, in the case of burning
out, please replace it with the same model.
15 Manual Clutch Handle
When power off, pull down the clutch
handle to shift to manual operation mode;
pulling down again to automatic operation
mode.
Restrictions on Use
1 In the case of power off and manual
mode is applied, OPEN/CLOSE limit should
not exceed 20cm of the learning time,
otherwise malfunction may occur when
power on.
2 When the door stays close to the top but
not limit top, press OPEN button, the door
will not open; when the door stays near the
bottom but not limit bottom, press CLOSE
button, the door will not close.
Loading ...
Loading ...
Loading ...