Loading ...
Loading ...
Loading ...
6.1.1 Put on the power plug, the digital display tube change
from to . Finally , see picture 9.
6.1.2 Press SET button for 4 seconds, when the display on
digital display tube from to and flicker, then hands off,
press the UP (▲) button once, the digital display tube turn
and flicker, then press SET one time and the digital display tube
shows , which means setting the proper position for door
closing.
6.1.3 Press CLOSE (▼) uninterrupted and the digital display
tube shows and flicker, meanwhile the door is closing.
(When hands off, the door will stop closing; if the door opens at
this time, that means the wrong setting of left side installation
and right side installation. In this case, the opener should be
power off then power on again. Please refer to 3.1 and turn
into . After the door is totally closed, release
CLOSE (▼), if
the door is not in proper position, please press
CLOSE (▼) or
OPEN (▲) once, to make the door close in the ideal place, then
press SET once again, the digital display tube turns , which
means to set the proper position after door totally opened.
6.1.4 Press (▲) uninterrupted, the digital display tube shows ,
then start to flicker, at the same time the door opens, when the
door is totally open, release (▲ ), if the door does not stop at an
ideal position, please press (▲ ) or (▼ ) once to make the door
stay at the ideal place. Repress SET once, the door will close
immediately and stop at the right totally closed position. Finally,
digital display tube shows and finish door travel position
settings.
Attention: After the ideal place for door closing and before
setting the ideal position for door opening, the position for
opening door ( height of opening door) stay should be within
1---3 meters; if the opening door height is beyond 1—3 meters,
when you press SET, the door will not close automatically, at
this time the courtesy light keep flickering for a while to show
that the wrong position and new settings should be done.
Picture 8
Picture 9
Installation
Drum-shaped
plastic wheel
7
SET
CO DE
OSC
SET
CO DE
OSC
SET
CO DE
OSC
SET
CO DE
OSC
SET
CO DE
OSC
SET
CO DE
OSC
SET
CO DE
OSC
SET
CO DE
OSC
SET
CO DE
OSC
5 Please fix the door curtain on the drum-shape plastic
wheel
The door curtain must be fixed firmly on the drum-shape plastic
wheel.
1 Close the door completely, make marks on the both sides
towards the plastic wheel.
2 Please find the marks when door is slightly open, use two
self-tapping screws on every side of the door curtain on plastic
wheel. Attention: the position of the two screws should be in the
90 degree direction, see picture 8.
6 Set up and down travel position
6.1 In the case of right side installation: please move the door to
the middle position manually, and draw the clutch handle （if
ERD1006 draw the green clutch handle) once to make sure
the door opener is in auto mode.
Loading ...
Loading ...
Loading ...