Loading ...
Loading ...
Loading ...
Features
ERDO are endowed with quite a few new
features. The components and materials used in
the control board are of the latest technology and
best quality. Following are the main features:
Easy Operation
Press the buttons of the handheld transmitter of
rolling door opener, the door will open or close
automatically. While the door is closing, simply
press the button, then the door will stop moving
down and open reversely. When opening, simply
press the button, then the door will stop moving.
Also, the above function can be achieved by
wall-mounted transmitter or wall switch (optional)
or the button on the cap of main control board.
Encryption Coding
Every time the remote control transmitter works,
the encryption coding will change once. The
possible password combination can be as much
as 4.29 billion, which enhances security
tremendously and makes “code-pirating”
impossible.
Intelligent Barrier Detection System
While the door is doing a closing cycle and hitting
an obstacle or be restricted in some manner, the
door can reverse automatically. Likewise, while
the door is opening and encountering an
obstacle, the door will close automatically. The
force of resistance should be adjusted via the
potentiometer of the main control board during
the initial installation. The force of resistance
should be checked at least once monthly, more
details please refer to installation instructions.
Security Code Storage of Transmitter
The latest advanced technology is applied in
encryption coding stored in transmitter. Up to 30
different code of transmitter can be stored. To
store any new code, simply press the CODE
button on the opener and press the transmitter
button twice, the transmitter code will be stored
immediately. The code can be deleted at any
time.
Automatic Courtesy Lights
The courtesy light on the Opener turns on
automatically whenever the door is activated to
do an opening or a closing cycle. When the
door stops moving, the courtesy light will stay
on for approximately three minutes then turns
off automatically.
Automatic Closing Mode
The Opener can be programmed to automatic
closing mode. The function of automatic delay
closing can be opted via the jumper on the
opener. I f this mode is selected, a photo beam
sensor must be installed.
Multiple Protection
Overtime protection; Low voltage protection;
Rotating speed fluctuation protection.
Manual Operation
The Opener is equipped with a manual
disengaging system. I f the power to the
Opener is cease for some reason, the door can
be shifted to manual mode by pulling down
string handle, in this situation manual open and
close is allowed. When the power is restored,
pull down the string handle then the opener is
back to the automatic mode.(The above
situation is suitable for single clutch-ERD1007;
if ERD1006—double clutches, pulling down the
red string for manual operation, pulling down
the green one for automatic operation mode).
Soft Start Soft Stop
This function can abate the impact on the door
caused by opening and closing the door
effectively.
Photo Beam Sensor(optional)
The Opener has an input for photo beam
sensor , which is to be connected for extra
safety protection. The photo beam sensor must
be installed if auto closing mode is chosen.
Loading ...
Loading ...
Loading ...