Loading ...
Loading ...
Loading ...
Situation
The opener doesnl
operate from either
the Wall Control or
the remote control:
Opener operates
from the remote
control, but not from
the Wall Control:
Having a Problem?
Probable Cause and Solution
1. Does the opener have electd.cpower? Plug.a lamp intothe outlei, ffitdoesn't light,
check the fuse box or the drcuit breaker. (Some outletsare controlledbya wall switch.)
2. Have you disabledall door locks?Review installationinstructionwarnings on Page 11.
3. Is there a build-up of ice or snow under the door? The door may be frozen to the
ground. Remove any restdction.
4. The garage door spdng may be broken. Have it replaced.
5. Repeated operation may have tripped the ovedoed protector in the motor. Wait
15 minutes. Try again.
1. Is the Wall Control lit?If not, remove the bell wire from the opener terminal screws.
Short the red and white terminals by touching bothterminals at the same time with a
piece of wire. If the opener runs, check for a faulty wire connection at the Wall
Control, a short under the staples, or a broken wire.
2. Are the widng connections correct? Review Step 6, page 18.
The door operates
from the Wall Control,
but not from the
remote control:
1. If your model has the Lookfeature, make sure the lock isOff.
2. Is any wall push button flashing? Your opener needs to re*learn a remote control
code. Refer to Instructionson the opener panel.
3. Does the battery test light glow when the remote control push button ispressed? If
not, replace the battery.
4. Program the receiver to match the remote control code.
5. Repeat the receiver programming procedure with all remote controls.
The remote control
has short range:
1. Check the battery test light. If the light isdim, replace the battery.
2. Change the location of the remote control in.your car.
3. Check to be sure the antenna on the side or back panel of opener extends fully
downward.
4.
Some installations may have shorter range due to a metal door. foil backed
insulation, or metal garage siding.
Opener noise Is
disturbing in riving
quarters of home:
If operational noise is a problem because of proximityof the opener to the living
quarters, the Vibration Isolator Kit 41A3263 can be installed. This kitwas designed to
minimize vibration to the house and iseasy to install.
The garage door
opens and closes
by Itself:
1. Be sure that all remote control push buttons and battery indicator lights are off.
2. Remove the bell wire from the Wall Control terminals and operate from the remote
control only. If this solves the problem, the Wall Control is faulty (replace), or there is
an intermittent short on the wire I_etween the Wall Control and the opener.
The door doesn,t
open completely:
1. If the door has been working prop6dy but now doesn't open all the way, increase the
up force. See page 29.
2. Is something obstructingthe door? Remove the obstructionor repair the door.
3. If door opens at least 5 feet, the travel limitsmay need to be increased. One tum
equals 2 inches of travel. See page 28.
Repeat the safety reverse test after the adjustment Is complete.
The door stops but
doesn,t close
completely:
Review the travel limitsadjustment procedures on page 28.
Repeat the safety reverse test after any adjustment of door arm length, close
force or down rimlL
34
Loading ...
Loading ...
Loading ...