Loading ...
Loading ...
Loading ...
12 WWW.SENIXTOOLS.COM
REPLACE CUTTING LINE
ADJUST IDLE SPEED
1. Open the cutting line spool by pressing the two
release buttons on the side. Take out the winding
core (Fig. A+B).
2. Divide a cutting line in 2 equal halves, x it in the
winding core and start to wind the cutting line in two
separated rails (Fig. B). Follow the indicated winding
direction.
3. Fix the 2 line ends (ca. 15 cm) at the opening to keep
the line winded tightly (Fig. C).
4. Guide the 2 line ends into the holes on the spool
housing and restore the spool cover (Fig. D).
0.6-0.8 mm
CLEANING
If the engine will not idle properly:
1. Start the engine. Refer to Starting and Stopping.
2. Release the throttle control and let the engine idle.
• If the engine stops, increase the idle speed. Use a
small Phillips screwdriver to turn the idle speed screw
clockwise, 1/8 of a turn at a time, until the engine idles
smoothly.
• If the cutting head spins when the engine idles,
reduce the idle speed. Turn the idle speed screw
counterclockwise, 1/8 of a turn at a time, until the
cutting head stops moving.
The cutting attachment should never turn at idle. Turn
the idle speed screw counterclockwise to reduce the
idle RPM and stop the cutting attachment, or contact
customer support for adjustment and discontinue use
until the repair is made. Serious personal injury could
result from the cutting attachment turning at idle.
To avoid serious personal injury, always stop the engine
and allow it to cool before cleaning or maintaining the
unit.
The cutting head will move when adjusting the idle
speed. Wear all protective clothing and keep all
bystanders, children, and pets at least 50 ft. away. Make
adjustments with the unit supported by hand so that the
cutting head does not contact the ground or any object.
Keep all parts of your body away from the cutting head
and mufer. Failure to follow these instructions could
result in serious personal injury.
The cutting attachment should never turn at idle. Turn
the idle speed screw counterclockwise to reduce the
idle RPM and stop the cutting attachment, or contact
customer support for adjustment and discontinue use
until the repair is made. Serious personal injury could
result from the cutting attachment turning at idle.
Use a small brush to clean the outside of the unit. Do
not use strong detergents. Household cleaners that
contain aromatic oils such as pine and lemon, and
solvents such as kerosene, can damage plastic. Wipe
off any moisture with a soft cloth.
WARNING:
WARNING:
WARNING:
WARNING:
B
C
D
A
Loading ...
Loading ...
Loading ...