Loading ...
Loading ...
Loading ...
16
For more information please visit
www.weller-tools.com.
Technical Data
soldering station WE 1
Dimensions L x W x H
(mm)
(Inch)
150 x 125 x 100
5,91 x 4,92 x 3,94
Weight (kg) 1,9
Mainssupplyvoltage ( V / Hz) 230 / 50/60
120 / 60
100 / 50/60
Power consumption (W) 85
Safetyclass I, antistatic housing
III, Soldering tool
Temperature range
Tool dependent
(°C)
(°F)
100 - 450
200 - 850
Temperatureaccuracy (°C/°F) Average tip tem-
perature can be
„offset“ to +/- 5°C
(+/-°9F) at idle with
no load
Temperaturestability (°C/°F) ± 6 / ± 10
Soldering iron WEP 70
Temperature range (°C / °F) 50-450
Power consumption
(W)
70
Mainssupplyvoltage
(V AC)
23
Heat-up time
(50°C to 350°C) (120°F to
660°F)
(s)
28
Tip top condition ET
Supplyunit WE 1
Subject to technical alterations and amendments.
Temperature performance
The soldering tool has an internal usage sensor which can
beusedtosetanautomaticswitch-offfunction(Stand-by).
The settings can be found in the station’s operating instruc-
tions.
User groups
Due to differing degrees of risk and potential hazards, sever-
alworkstepsmayonlybeperformedbytrainedexperts.
Work step User groups
Default soldering para-
meters
Specialist personnel with
technical training
Replacing electrical repla-
cement parts
Electricians
Default maintenance
intervals
Safetyexpert
Operation
Filter change
Non-specialists
Operation
Filter change
Replacing electrical
replacement parts
Technical trainees under
the guidance and supervi-
sion of a trained expert
Care and maintenance
WARNING
Before doing any work on the machine, pull
the plug out of the socket. Leave the unit to
cool down.
Check all connected cables and hoses on a regular basis. If
powertoolsaredamaged,theymustbeimmediately
removed from use.
Onlyreplacethesolderingtipswhentheyarecold.
Thesolderingtoolmustbeleftswitchedoffinthesafetyrest
for at least 3 minutes until the soldering tip has cooled down.
The LED status indicator must be at „OFF“.
Keep the heat transfer surfaces of the soldering tip and
heating element clean. The heating element must not come
into contact with soldering tin.
Repairs must always be referred to a Weller-trained
specialist.
Useoriginalreplacementpartsonly.
Warranty
Claimsbythebuyerforphysicaldefectsaretime-barred
afteraperiodofoneyearfromdeliverytothebuyer.This
doesnotapplytoclaimsbythebuyerforindemnicationin
accordance with §§ 478, 479 BGB (German Federal Law
Gazette).
Weshallonlybeliableforclaimsarisingfromawarranty
furnishedbyusifthequalityordurabilitywarrantyhasbeen
furnishedbyuseinwritingandusingtheterm„Warranty“.
Thewarrantyshallbevoidifdamageisduetoimproperuse
andifthedevicehasbeentamperedwithbyunauthorised
persons.
EN
ENGLISH
Loading ...
Loading ...
Loading ...