Loading ...
Loading ...
Loading ...
www.SereneLifeHome.com
18
Jumper3 66
Attach a spring to hole 5 of the corresponding eyelet and from there attach a
spring every nine holes. For even distribution of the tension and an easier assembly,
each of the springs should be attached to the opposite sides of the mat/the frame,
i.e. rst 5 then 41,14 then 50, etc. In addition to the previously attached springs,
you should have springs at 5,14, 23, 32, 41,50, 59 and 68.
Jumper 430
Attach a spring to hole 6 of the corresponding eyelet and from there attach a
spring every nine holes. For even distribution of the tension and an easier assembly,
each of the springs should be attached to the opposite sides of the mat/the frame,
i.e. rst 6 then 50,17 then 61, etc. In addition to the previously attached springs,
you should have springs at 6,17, 28, 39, 50, 61,72 and 83.
I. Now attach a spring every four holes or to the corresponding eyelets. For even
distribution of the tension and an easier assembly, each of the springs should be
attached to the opposite sides of the mat/the frame.
J. Then attach all remaining springs by using the same method of counting down
equal holes.
CAUTION
If you realize you have lost count, recount and remove or attach the necessary springs
to obtain the necessary number of springs.
Attaching the frame padding
WARNING
Never use the trampoline without the frame padding attached tie the frame padding
down properly before every use! Make sure that the safety padding of the trampo-
line is securely positioned on the trampoline.
Step 5 - Instructions for assembly of frame padding
A. Place the frame pad (112) on the steel ring frame and tie the elastic to the leg base
as shown in the drawing.
Loading ...
Loading ...
Loading ...